# # inittab This file describes how the INIT process should set up # the system in a certain run-level. # # Author: Miquel van Smoorenburg, # Modified for Sixnet IPm Linux by Dave Ellis # # Default runlevel. The runlevels used by RHS are: # 0 - halt (Do NOT set initdefault to this) # 1 - Single user mode # 2 - Multiuser, without NFS (The same as 3, if you do not have networking) # 3 - Full multiuser mode # 4 - unused # 5 - X11 # 6 - reboot (Do NOT set initdefault to this) # id:3:initdefault: # System initialization. si::sysinit:/etc/rc.sysinit # Single user shell sh:1:respawn:/bin/sh < /dev/console > /dev/console 2> /dev/console # Start the monit process mon:34:respawn:monit -I > /dev/null 2>&1 # networking ne:34:once:/usr/sbin/inetd # Sixnet ISaGRAF runtime sx1:3:respawn:isagraf # Sixnet applications l0:0:wait:/sbin/halt -dip #l1:1:wait:/etc/rc.d/rc 1 #l2:2:wait:/etc/rc.d/rc 2 l3:3:wait:/etc/rc 3 l4:4:wait:/etc/rc 4 #l5:5:wait:/etc/rc.d/rc 5 l6:6:wait:/sbin/reboot -dip # Run gettys in standard runlevels #T0:234:respawn:/sbin/getty -L ttyS00 9600 T0:4:respawn:/sbin/getty -L ttyS00 9600 #T1:234:respawn:/sbin/getty -L ttyS01 9600 #T2:234:respawn:/sbin/getty -L ttyS02 9600 #T3:234:respawn:/sbin/getty -L ttyS03 9600 # # Run getty on USB serial device. This is # a call to a wrapper script in case there is # no USB. TU:234:respawn:/usr/local/bin/ttygserial # Dialup Lines #D0S:234:respawn:/usr/sbin/mgetty -n 1 -D ttyS00 #D1S:234:respawn:/usr/sbin/mgetty -n 1 -D ttyS01 #D2S:234:respawn:/usr/sbin/mgetty -n 1 -D ttyS02 #D0C:234:respawn:/usr/local/bin/sxpppd ttyS00 #D1C:234:respawn:/usr/local/bin/sxpppd ttyS01 #D2C:234:respawn:/usr/local/bin/sxpppd ttyS02 #svm:34:respawn:/usr/local/bin/jbm_mgmt -i >/dev/null # Reset hwclock hcw:3:once:/sbin/hwclock -w