Applicable Products:
All PXU Controllers.
Tools needed:
Small Tech screwdriver
Gain Access to Program:
Enter the Program follow the instructions to gain access:
1.) Press the P button until CODE is displayed, and or Press and Hold the P button. if you do not see CODE. you may have to keep pressing P momentarily until CODE is displayed.
2.) When CODE is displayed, enter 111 by holding down the UP-arrow button. Then press the P button.
3.) As long as a USER input is not programmed for PLOC the controller should allow access to the 9 different modules to be configured.
USER Inputs settings:
1.) If a USER input is programmed for PLOC then you must Lift one end of the jumper that is installed.
2.) The terminals will change in relation to the size of the Controller. Below I have Listed the 3 different sizes of Controllers:
1/ 16 Din = Terminals #13 & #14 = USER1 or Terminals #15 & #16 USER2
1/8 or 1/4 Din = Terminals #20 * #21 USER1 or Terminals #18 & #19 = USER2