Articles in this section

See more

Crimson 3.x: System Console

Avatar
Red Lion Controls
  • Updated
Follow

Industrial Automation Tech Note 22 - TNIA22

Abstract:  

This document explains how to use the System Console with the Graphite® Controllers.

Products:  

Graphite Controllers, Data Acquisition (DA10 & DA30), FlexEdge (DA50D & DA70D)

Use Case: Graphite Controller System Console

The System Console allows for the configuration of the Ethernet port and clearing the unit’s memory via a USB connection.

Required Software:  

Crimson® 3.0

Required Firmware:  

Crimson 3.0 Build 692.000+

Crimson 3.1 All Build

Place Unit in Console Listening Mode

GRAC00C5

  1. Connect the controller to PC via a USB cable.
  2. Press and hold factory reset button on the unit.
  3. Apply power to the unit.
  4. Continue holding reset button until the green LED on the unit turns on solid while the red and blue LEDs begin blinking twice per second.

GRAC00C1

  1. Connect the controller to a PC via a USB cable.
  2. Press and hold the factory reset button on the unit.
  3. Apply power to the unit.
  4. Continue holding the reset button until the green LED begins blinking twice per second.

DA10/DA30

  1. Connect the controller to a PC via a USB cable.
  2. Press and hold the factory reset button on the unit.
  3. Apply power to the unit.
  4. Continue holding reset button until the green LED on the unit turns on solid while the red and blue LEDs begin blinking twice per second.

DA50D/DA70D

  1. Connect the controller to a PC via a USB cable.
  2. Press and hold the factory reset button on the unit.
  3. Apply power to the unit.
  4. Continue holding the reset button until the HALO LED on the unit blinks white twice per second.

Launch System Console

Crimson 3.0/3.1

  1. Click Link-Options…
  2. Select
  3. Click OK.
  4. Click Link-System Console…, see Figure 1.
  5. Configure Network Settings as needed or verify the system Details.
  • The Refresh button will refresh the Network Settings.
  1. Click Close and Restart to apply new settings (if applicable) and reboot controller.

Screenshots.jpg

Figure 1.

Status does not show a Ready state.

  1. Close the console.
  2. Verify Link-Options
  3. Verify the physical connection.
  4. Verify that the controller is in listening mode.
  5. Click Link-System Console to attempt a new connection.

Disclaimer

It is the customer's responsibility to review the advice provided herein and its applicability to the system. Red Lion makes no representation about specific knowledge of the customer's system or the specific performance of the system. Red Lion is not responsible for any damage to equipment or connected systems. The use of this document is at your own risk. Red Lion standard product warranty applies.

Red Lion Technical Support

If you have any questions or trouble contact Red Lion Technical Support by clicking here or calling 1-877-432-9908.

For more information: http://www.redlion.net/support/policies-statements/warranty-statement

Related articles

Powered by Zendesk